NewPac Setup / Raspberry Pi

Jasi

Last Update il y a 2 mois

Preparation, Package Dependencies, Configuration and Build for Raspbian – Kernel version: 4.4 (Debian 8.7.1) or higher of for Ubuntu 16.04.1 LTS or higher


Preparation


This installation guide describes the setup, configuration, and build based on a freshly installed Raspbian (Debian) or Ubuntu installation. You will need sudo rights. It’s not necessary to use root.


First steps: update and upgrade of the system and required packages:

sudo apt-get update

sudo apt-get upgrade -y


sudo apt-get install -y build-essential git autoconf automake libtool pkg-config libcurl4-openssl-dev libudev-dev libusb-1.0-0-dev libncurses5-dev


Now you can clone the GekkoScience CGMiner branch from GIT:


mkdir -p mining/newpac; cd mining/newpac

git clone https://github.com/vthoang/cgminer.git

cd cgminer


After successful cloning you can start to build CGMiner:

CFLAGS="-O2" ./autogen.sh --enable-gekko

make -j 2


The build command for Ubuntu 16.04.1 LTS (or higher) is slightly different:


CFLAGS="-O2 -march=native" ./autogen.sh --enable-gekko

make -j 2


Explanation notes: The build parameter –enable-gekko activates the GekkoScience drivers both for Compac (single ASIC) and 2Pac (dual ASIC).

Now test the newly built binary:


./cgminer -n


The following command will start up the CGMiner Software (example):


cd ~/mining/newpac/cgminer

./cgminer 


  • Url: stratum+tcp://198.44.96.109:3256 (enter if you have own pool address)(mining.dsfr.ch)
  • Username: 1BURGERAXHH6Yi6LRybRJK7ybEm5m5HwTr (Enter your Wallet id)
  • Password: (anything you can enter)

Was this article helpful?

0 out of 0 liked this article

Still need help? Message Us